← Dallas Automation
Dallas Automation

The prewire checklist

For new builds and major remodels
Hand this to your builder before insulation

Wire is cheap while the walls are open and expensive after. You do not need to buy every system now. You need the cable, power and blocking in place so that you can add any of them later without cutting drywall.

Equipment location

  • One closet or mechanical space where every cable endsNot the attic. Texas attics are too hot for electronics.
  • Room for a floor-standing rack, with ventilation or a return-air path
  • Dedicated power circuits at the rack location
  • Conduit from the internet provider's entry point to the rack
  • Two spare conduits from the rack to the attic for the future

Network and Wi-Fi

  • Network cable to every TV location, two runs each
  • Network cable to each office desk and to the kitchen desk
  • Ceiling drops for Wi-Fi access points on every floorPlaced from a coverage plan, not at the ends of hallways.
  • Access point locations for the patio, garage and guest house
  • Buried conduit to any detached building or gate

Lighting control

  • Decide on centralized (panelized) or in-wall dimming before electrical rough-in
  • Low-voltage wire to every keypad location
  • Keypad heights and locations marked on the framing
  • Space next to the electrical panels for lighting panels, if centralized
  • Fixture schedule shared with the lighting control designer

Motorized shades

  • Shade pockets framed above the windows that will get them
  • Power or low-voltage wire at the head of each window, on the correct side
  • Solid blocking at every shade mounting point
  • Wire for tall and hard-to-reach windows, even if shades come later

Music

  • Speaker wire to two ceiling locations in every room you may want sound
  • Speaker locations coordinated with can lights, vents and beams
  • Speaker wire to the patio, pool and outdoor kitchen
  • Conduit under hardscape for landscape speakers

TVs and media rooms

  • Recessed power and blocking behind every wall-mounted TV
  • Conduit from each TV to a cabinet or to the rack
  • Wire for a soundbar or front speakers at the main TVs
  • In a media room: wire for surround and ceiling speakers, and a subwoofer on each end of the room
  • Projector power and conduit, plus a recess or blocking for the screen
  • Lighting in the room on its own dimmable zones

Outdoors

  • Power, network cable and blocking for a patio TV
  • Network cable to the front door for a video doorbell
  • Conduit to the driveway gate and the pool equipment pad

Comfort and voice

  • Thermostat wire with extra conductors at each thermostat
  • Network cable to ceiling or wall locations for voice microphones in the main rooms
  • Remote temperature sensor wire in rooms that run hot or cold

Before the drywall goes up

  • Photograph every wall and ceiling with the wire in place
  • Label both ends of every cable
  • Walk the house with the plan and check each location off

Want this drawn for your plans? Send us the drawing set and we will mark every location on it for your builder and electrician. Call (214) 555-0100 or write to hello@dallasautomation.com.